If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP 560C
My HP 560C works fine except when I first start it up it goes through some
kind of start-up routine and then, as it places the ink cartridges back into their resting position, it emits a "crunch" sound and all the lights on the control panel blink. If I turn it off and back on it will go through the start-up routine, place the ink cartridges back into the resting position, and be ready to go. I can then print successfully. Any ideas? |
#2
|
|||
|
|||
David Glass wrote:
My HP 560C works fine except ... I can then print successfully. Any ideas? Buy one or two for parts, or complete replacements, on eBay. They're cheap, so cheap that I've haven't even considered trying to sell the one (I think) I still have around here somewhere. -- Regards, Bob Niland http://www.access-one.com/rjn email4rjn AT yahoo DOT com NOT speaking for any employer, client or Internet Service Provider. |
#3
|
|||
|
|||
David Glass wrote:
My HP 560C works fine except when I first start it up it goes through some kind of start-up routine and then, as it places the ink cartridges back into their resting position, it emits a "crunch" sound and all the lights on the control panel blink. If I turn it off and back on it will go through the start-up routine, place the ink cartridges back into the resting position, and be ready to go. I can then print successfully. Any ideas? Mine used to do that after I'd had it for several years, I don't think I ever fixed it but it carried on working in that state for a long time. The "crunch" sound is the toothed rubber drive belt slipping I think. Where are you by the way, I have a twin pack colour cartridge which I'll post to you for free if you're in the UK. It's past its sell by date but is proably OK still. -- Chris Green |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HP Deskjet 560C power supply | nowonmai | Printers | 4 | July 11th 04 06:50 PM |
Replacing Tektronics 560c -- any suggestions? | Kim Webb | Printers | 0 | October 22nd 03 03:58 PM |
Replacing Tektronics 560c -- any suggestions? | Kim Webb | Printers | 0 | October 22nd 03 03:58 PM |