|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 25th 04, 08:27 PM
|
|||
|
|||
SCSI CDRW won't boot now
Hi, I am not sure if this is the right NG for this but here goes.
I have a SCSI CDRW drive (Plexwriter), and a DVD Writer installed as Secondary Master. Now prior to installing the DVD writer all my boot CD's would boot from the SCSI drive, but now they won't and will only boot from the DVD writer/drive which is a pain because that writer/drive is too slow compared to the SCSI drive. I am not sure what the dvd drive (Pioneer 106) reads CDs at, but the SCSI drive reads them at x32. Any ideas as to how I can get the SCSI drive to boot CDs again? Thanks -- Bob H Leeds UK 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't boot from CD | Zotin Khuma | General | 6 | November 16th 04 10:18 PM |
| Boot problem with Promise SATA Fasttrack S150TX2 Plus | Wizard | General | 0 | September 13th 04 06:54 PM |
| CDRW not being detected as pri or sec slave... | Fredericks | Homebuilt PC's | 3 | April 21st 04 04:52 AM |
| CDRW not being detected as pri or sec slave... | Fredericks | General | 2 | April 18th 04 10:01 PM |
| SCSI trouble | Alien Zord | General | 1 | June 25th 03 03:08 AM |
Threaded Mode