If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Eltron TLP2046 Increase Heat Density with Command Prompt
We have a Eltron TLP 2046 label printer. We need to be able to
increase the heat density on the thermal transfer head to get a darker image. This can be done through software drivers but we use a windows Generic / Text driver which does not allow you to change the setting. Now, there is a way to increase it through DOS or command prompt because I have done it before but can't remember the command. Does anyone have any ideas, quick fixes, or know the command to increase this setting through the command prompt? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Idle 52C - Full Load 60C | Jack Spungo | Overclocking AMD Processors | 36 | December 3rd 04 06:47 PM |
Opteron Overclocking? | Adrian Richards | Overclocking AMD Processors | 9 | October 5th 03 03:20 PM |
Cooling Questions | Peter Cavan | General | 35 | September 2nd 03 06:42 AM |
Cooling Questions | Peter Cavan | Overclocking | 37 | September 2nd 03 06:42 AM |
Cooling Questions | Peter Cavan | Homebuilt PC's | 35 | September 2nd 03 06:42 AM |