If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Color problem with Agfa SnapScan e50 and ScanWise 2.0.0.9 under XP Home
During the preview phase - while the scanner is working -
a photo is shown in correct colors. As soon as the preview phase is over and the frame is shown, the photo appears in ugly red/violet colors. I have already tried: 1. Installation of ScanWise 2.0.0.9 on a recently built XP system (i.e. ScanWise is the last software installed) 2. Deleting one of the color profiles (e50 Agfa Rx and Tx) and only using the other one 3. Running ScanWise 2.0.0.9 in Windows 95 compatibility mode No success so far. Any ideas would be much appreciated! :-) Albrecht Mueller |
Thread Tools | |
Display Modes | |
|
|