If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Norton Ghost - Clone Won't Work
I have physical hard drive "C" with Win98 and physical hard drive "D"
with WinXP in a dual boot setup. I want to injstall a new, larger physical hard drive "D". I have tried to follow the procedure for cloning a drive using Norton Ghost. I disconnected the cables from "C" and connected the new hard drive. (I set the new drive's jumper to "master" the same as the "C" drive.) Then Norton Ghost was booted from floppies and I cloned drive 2 to drive 1. This all seemed to OK. Then I disconnected the new drive and changed the jumper to "slave". Then I reconnected the "C" drive. Then I disconnected the "D" drive and connected the new drive in it's place. Now when I boot to WinXP it fails just after the WinXP splash screen. A blue screen with an error message appears and the system reboots. Any insight will be appreciated. jimbo |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clone IDE to SATA hard drive | TOM B WILSON | Homebuilt PC's | 3 | October 2nd 04 09:46 PM |
isolating new clone drive for 1st bootup | Timothy Daniels | General | 86 | February 29th 04 03:37 PM |
DELL upgrade with Kingston Value RAM - will it work properly | stromer | General | 0 | January 31st 04 08:29 AM |
Can't get two CD drives to work on XP machine | Bruce | General | 2 | September 5th 03 01:01 AM |
clone harddisk | Ralph Mowery | General | 1 | August 24th 03 12:40 AM |