|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 14th 03, 07:11 AM
|
|||
|
|||
StorageTek L180 and L700 Temperature Related Gripper Problems
On both the StorageTek L180 and L700 tape libraries, I have noticed that if
the library is run in an environment with a high ambient temperature (over about 80-to-85 degrees), you start to get problems with tapes getting stuck in the gripper. Once this happens, the library fails initialization right after exercising the gripper, and the FSC code refer to Z and Theta problems. Power off the library for five minutes and the library can pass initialization, but after a short time period if you re-initialize it will fail again, in the identical way. As I said, I have seen this on both the L180 and L700, and I test quite a few of both of these models. Has anyone else observed this? -- Will westes AT earthbroadcast.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
