If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
No dma sw mode support for cd writer
Hi, I have an Asus P4PE and Intel Application Accelerator but I cannot
get DMA support for my cd writer to work, secifically it says in IAA DMA SW Mode Support: No Support. Operating System Windows XP (Build 5.1.2600, Service Pack 2) Platform Information Processor Type: Intel(R) Pentium(R) 4 Processor Processor level: Family 15 Processor Revision: Model 2 Stepping 9 Active Processor Mask: 1 Number of Processors: 1 Controller Information IDE Controller: Intel(R) 82801DB Ultra ATA Controller, ICH4 Storage Kit Build(s): 2.3.0.2164, Storage Kit Installed: 2.3.0.2164 Driver Build: Intel Application Accelerator Driver Driver Version: Feature not supported by driver. IDE Controller Tri-State: IDE Controller enabled PIO Mode Support: 0 - 2 - 3 - 4 DMA SW Mode Support: 2 DMA MW Mode Support: 1 - 2 UDMA Mode Support: 0 - 1 - 2 - 3 - 4 - 5 Disk Timeout Value: Default CDROM Timeout Value: Default CD Audio Timeout Value: Default UDMA on 80 conductor cable only: Default, Disabled Flush Enable: Default, Disabled Ping Pong Enable: Enabled Channel Information Primary Channel No Data Secondary Channel No Data Device Information Primary Master: HL-DT-STDVD-ROM GDR8161B Model: HL-DT-STDVD-ROM GDR8161B Firmwa 0100 Device Type: ATAPI - Removable - CDROM PIO Mode Support: 0 - 1 - 2 - 3 - 4 DMA SW Mode Support: 0 - 1 - 2 DMA MW Mode Support: 0 - 1 - 2 UDMA Mode Support: 0 - 1 - 2 Default Transfer Mode: UDMA-2 Current Transfer Mode: UDMA-2 Transfer Mode Limit: No Limit Cable Type (Device): 40 Conductor Cable Type (Host): 40 Conductor PIO PPE: Disabled UDMA Control Register: Ultra DMA Mode Disabled Auto-Acoustic Management: Feature not supported by device. Dynamic APM on AC: Feature not supported by device. Dynamic APM on Battery: Feature not supported by device. Primary Slave: SONY CD-RW CRX230ED Model: SONY CD-RW CRX230ED Firmwa 4YS1 Device Type: ATAPI - Removable - CDROM PIO Mode Support: 0 - 1 - 2 - 3 - 4 DMA SW Mode Support: No Support DMA MW Mode Support: 0 - 1 - 2 UDMA Mode Support: 0 - 1 - 2 Default Transfer Mode: UDMA-2 Current Transfer Mode: UDMA-2 Transfer Mode Limit: No Limit Cable Type (Device): 40 Conductor Cable Type (Host): 40 Conductor PIO PPE: Disabled UDMA Control Register: Ultra DMA Mode Disabled Auto-Acoustic Management: Feature not supported by device. Dynamic APM on AC: Feature not supported by device. Dynamic APM on Battery: Feature not supported by device. |
#2
|
|||
|
|||
Make sure that your IDE cables are 80-pin and not 40-pin to achieve speeds
higher than DMA33. This report says they are 40-pin cables. "ggroups2" wrote in message ... Hi, I have an Asus P4PE and Intel Application Accelerator but I cannot get DMA support for my cd writer to work, secifically it says in IAA DMA SW Mode Support: No Support. Operating System Windows XP (Build 5.1.2600, Service Pack 2) Platform Information Processor Type: Intel(R) Pentium(R) 4 Processor Processor level: Family 15 Processor Revision: Model 2 Stepping 9 Active Processor Mask: 1 Number of Processors: 1 Controller Information IDE Controller: Intel(R) 82801DB Ultra ATA Controller, ICH4 Storage Kit Build(s): 2.3.0.2164, Storage Kit Installed: 2.3.0.2164 Driver Build: Intel Application Accelerator Driver Driver Version: Feature not supported by driver. IDE Controller Tri-State: IDE Controller enabled PIO Mode Support: 0 - 2 - 3 - 4 DMA SW Mode Support: 2 DMA MW Mode Support: 1 - 2 UDMA Mode Support: 0 - 1 - 2 - 3 - 4 - 5 Disk Timeout Value: Default CDROM Timeout Value: Default CD Audio Timeout Value: Default UDMA on 80 conductor cable only: Default, Disabled Flush Enable: Default, Disabled Ping Pong Enable: Enabled Channel Information Primary Channel No Data Secondary Channel No Data Device Information Primary Master: HL-DT-STDVD-ROM GDR8161B Model: HL-DT-STDVD-ROM GDR8161B Firmwa 0100 Device Type: ATAPI - Removable - CDROM PIO Mode Support: 0 - 1 - 2 - 3 - 4 DMA SW Mode Support: 0 - 1 - 2 DMA MW Mode Support: 0 - 1 - 2 UDMA Mode Support: 0 - 1 - 2 Default Transfer Mode: UDMA-2 Current Transfer Mode: UDMA-2 Transfer Mode Limit: No Limit Cable Type (Device): 40 Conductor Cable Type (Host): 40 Conductor PIO PPE: Disabled UDMA Control Register: Ultra DMA Mode Disabled Auto-Acoustic Management: Feature not supported by device. Dynamic APM on AC: Feature not supported by device. Dynamic APM on Battery: Feature not supported by device. Primary Slave: SONY CD-RW CRX230ED Model: SONY CD-RW CRX230ED Firmwa 4YS1 Device Type: ATAPI - Removable - CDROM PIO Mode Support: 0 - 1 - 2 - 3 - 4 DMA SW Mode Support: No Support DMA MW Mode Support: 0 - 1 - 2 UDMA Mode Support: 0 - 1 - 2 Default Transfer Mode: UDMA-2 Current Transfer Mode: UDMA-2 Transfer Mode Limit: No Limit Cable Type (Device): 40 Conductor Cable Type (Host): 40 Conductor PIO PPE: Disabled UDMA Control Register: Ultra DMA Mode Disabled Auto-Acoustic Management: Feature not supported by device. Dynamic APM on AC: Feature not supported by device. Dynamic APM on Battery: Feature not supported by device. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Who makes the best DVD writer? | Robert TV | General | 2 | August 21st 04 03:28 PM |
Need motherboard recommendation | Ray Mitchell | Asus Motherboards | 17 | July 19th 04 11:48 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
a7n8x AGP not working? | Soulcatcher | Asus Motherboards | 6 | November 21st 03 02:54 PM |
CD Writer/ DVD Writer software on new build | HMSDOC | Homebuilt PC's | 0 | October 29th 03 12:01 PM |