|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 1st 04, 06:06 PM
|
|||
|
|||
Gigabyte 8IK1100 Rev 2. - No POST beep or graphics.
Hello,
I have a 8IK1100 Rev 2 with a 3.0 GHZ HT P4 that has died. The power supply is good, but when I power on, my graphics card does not init and there are no POST beeps. The LED near the memory sockets is on. I've removed all cards but the video card with no luck. I've also replaced the video card with a known good card, no luck. Is there any way to determine if the problem is with the CPU or motherboard? Unfortunately, I don't have another system I can swap the CPU with. -Randy 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Upgrade Report [Superfast Graphics - 01/11/2005] | Ablang | General | 0 | January 15th 05 03:47 AM |
| 010813603026 money 010813603026 | RASCH | Overclocking AMD Processors | 0 | February 14th 04 10:15 PM |
| A7V133-VM + PCI video = BEEP BEEP BEEP BEEP? | Lost | Asus Motherboards | 2 | November 13th 03 05:33 AM |
| Is Gigabyte support just a sour joke? | Thorsten Helmerichs | Gigabyte Motherboards | 3 | October 25th 03 05:07 PM |
| no post, no beep...cpu failure? | dryOtto | Overclocking AMD Processors | 6 | June 30th 03 11:52 PM |
Linear Mode
