If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Xp 2800+ now running at 10.5 x 200 fsb is it better???
I have a Xp 2800 (non barton) which should run at 2.25 Ghz and 333mhz
fsb, if you see my previous post last week i was haveing trouble running it at this speed. For the last 3 days i have lowered the multiplier to 10.5 and bumped up the fsb to 200mhz. So in effect my FSB is now 400 and my processor running at 2.1 ghz. Am i getting better performance with a higher fsb than i would have if my cpu ran at 2.25ghz + 333 fsb??? My memory and motherboard are also running at 400mhz. Cooling does not seem to be a problem, my MB temp is about 32 and my cpu about 50. Any advice would be great. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Xp 2800+ now running at 10.5 x 200 fsb is it better??? | edrafp | Overclocking AMD Processors | 2 | June 26th 05 03:36 AM |
Xp 2800+ now running at 10.5 x 200 fsb is it better??? | edrafp | AMD Thunderbird Processors | 2 | June 26th 05 03:36 AM |
running a 2800+ barton with a 400 MHz FSB | Chip | Overclocking AMD Processors | 10 | January 12th 04 08:24 PM |
running a 2800+ barton with a 400 MHz FSB | Simon | Asus Motherboards | 7 | January 12th 04 08:24 PM |
running a 2800+ barton with a 400 MHz FSB | Chip | Asus Motherboards | 2 | December 17th 03 12:45 PM |