|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 14th 04, 09:50 AM
|
|||
|
|||
Bi-directional support
I am trying to configure Bi-directional support for my HP 695c.
I am using windows 98, and a PCI printer port that supports EPP,ECP & BPP. When I go to the spool settings on the printer driver, the "enable bi-directional support" options are grayed out. What do I have to do to enable these? 
|
|
#2
September 14th 04, 10:39 AM
|
|||
|
|||
|
Allan M wrote:
I am trying to configure Bi-directional support for my HP 695c. I am using windows 98, and a PCI printer port that supports EPP,ECP & BPP. When I go to the spool settings on the printer driver, the "enable bi-directional support" options are grayed out. What do I have to do to enable these? Is it enabled in the BIOS? Read the system manual to find out how to change settings. -- My great-grandfather was born and raised in Elgin - did he eventually lose his marbles?
|
|
#3
September 15th 04, 08:20 AM
|
|||
|
|||
|
I dont think that is the problem, as I have another (for a different type of
printer)driver installed, and on that one the bi-directional option is not grayed out. Miss Perspicacia Tick wrote in message news  Allan M wrote: I am trying to configure Bi-directional support for my HP 695c. I am using windows 98, and a PCI printer port that supports EPP,ECP & BPP. When I go to the spool settings on the printer driver, the "enable bi-directional support" options are grayed out. What do I have to do to enable these? Is it enabled in the BIOS? Read the system manual to find out how to change settings. -- My great-grandfather was born and raised in Elgin - did he eventually lose his marbles?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vin, Gateway's Expert: "We do not support Linux".35 minutes to find this out... | Cal Cerise | Gateway Computers | 1 | July 24th 04 01:12 AM |
| ATI R420 WONT SUPPORT 3.0 SHADERS | wired and confused | Ati Videocards | 11 | April 23rd 04 05:18 AM |
| LITEON's dark secret? | No Longer a LiteOn Customer | Homebuilt PC's | 49 | April 15th 04 04:41 AM |
| Tech support question | Dr. Indera | Gateway Computers | 6 | February 7th 04 07:09 AM |
| Thinking of buying a Dell? Think again! | Psychomation | Dell Computers | 98 | January 20th 04 01:59 AM |
Linear Mode
