If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Kyocera fs-400: How to clean the Blade
Has anyone an idea how to do this? Can I disassemble the PU? The problem I have is that this fs-400 prints a ghost-picture as a narrow vertical bar Bye Stefan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dremel Metal cutting blade advice needed., thanks. | Little TeaPot | Homebuilt PC's | 9 | September 14th 04 10:17 AM |
Blade Server with PCI Slot? | Hyochang Nam | General Hardware | 0 | July 8th 04 09:20 AM |
To clean or not to clean.. that is the question... | jkh | Printers | 6 | August 21st 03 10:41 PM |
Success: New MB without clean install of XP | John | Asus Motherboards | 17 | August 5th 03 04:56 PM |
Kyocera FS600 laser printer image problems | Nigel Jones | Printers | 0 | July 6th 03 03:43 PM |