If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
problem with powerstrip
I cannot separately set horizontal and vertical fequencies in
Powerstrip, it seems they're locked up: ie, if I set horizontal at 85 Khz, also the vertical frequency updates to 85 Khz as well, while usenet is plenty of guys switching to any fequency they want all day long |
#2
|
|||
|
|||
problem with powerstrip
what monitor?
what video card? "orsobubu" wrote in message oups.com... I cannot separately set horizontal and vertical fequencies in Powerstrip, it seems they're locked up: ie, if I set horizontal at 85 Khz, also the vertical frequency updates to 85 Khz as well, while usenet is plenty of guys switching to any fequency they want all day long |
#3
|
|||
|
|||
problem with powerstrip
Hi Jad, I'm tring to use an old IBM monitor (powerdisplay 19) and I'm
unable to find specifications online about its frequencies, since I know it can support only a few modes; i know for sure it supports 1280x960 at V75 x H80 (used by a friend of mine). I installed TightVNC on a network to remotely control this monitor connected to a Quadro4 900XGL, and with powerstrip i was tweaking the parameters, but I can't get different H and V frequencies, and any locked frequency I try for 1280x960 don't seem to work... |
#4
|
|||
|
|||
problem with powerstrip
using the BNC connectors?
in the monitors OSD you could have the V H locked.... found a PD 20 specs, showed a V H control in the OSD "orsobubu" wrote in message oups.com... Hi Jad, I'm tring to use an old IBM monitor (powerdisplay 19) and I'm unable to find specifications online about its frequencies, since I know it can support only a few modes; i know for sure it supports 1280x960 at V75 x H80 (used by a friend of mine). I installed TightVNC on a network to remotely control this monitor connected to a Quadro4 900XGL, and with powerstrip i was tweaking the parameters, but I can't get different H and V frequencies, and any locked frequency I try for 1280x960 don't seem to work... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dell's Sorry History of Microphone/Soundcard Issue (Update) | Class_Action | General | 127 | January 20th 06 09:30 PM |
Dell's Sorry History of Microphone/Soundcard Issue (Update) | Class_Action | Dell Computers | 121 | December 12th 05 12:47 PM |
Dell's Sorry History of Microphone/Soundcard Issue | Ted Zieglar | Dell Computers | 16 | October 31st 05 03:09 AM |
Dell's Sorry History of Microphone/Soundcard Issue | Attorney General | Dell Computers | 1 | October 27th 05 12:34 AM |