If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New SATA drive not "seen" P4PE
I have a P4PE with SATA connectors. I have installed a new Hitachi
120GB hdd and have tried to have it recognized by enabling the SATA/RAID controller and enabling ATA onboard first options but to no avail. On POST the Primary drive reports None. The drive is a mirror of an IDE drive and is replete with OS and files. I can "see" that these files are all there when I have gone into Win2000 Command Console but I cannot get the drive to boot, presumably because it is not recognized. Before I go further, I would like to know if there are any other BIOS settings that I need to tweak. For example, does it do anything to a SATA drive if I define the Primary Hard drive specs (cylinders, etc.) or does that only pertain to the hdd on the Primary IDE connector? Thanks Ken K |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about transfer speeds between HDs, and DMA mode | ZigZag Master | Overclocking AMD Processors | 25 | July 25th 04 09:56 PM |
Formating SATA Drive on P4PE | Avery | Asus Motherboards | 5 | June 9th 04 01:06 AM |
Intel 875 Mobo and RAID. Is this rightso far? | K G Wood | Homebuilt PC's | 7 | April 19th 04 06:17 AM |
A7N8X De Luxe and dual SATA drive problems | Chris Wilson | General | 0 | November 30th 03 08:44 PM |
BAD peformance of all single SATA drives on Asus P4P800/P4C800 mobos?!.. | koop | Asus Motherboards | 1 | June 22nd 03 09:59 PM |