If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ATX Case - 5 5.25 drive bays
Looking for atx case. Need:
1. 5 or more external 5.25 inch drive bays, 1 or more external 3.5 inch drive bay. Since I always use removeable drive drawers for my "internal" hard disk access, 5.25 inch drive bays must be external. 2. Mildly prefer case height = 20 inches. 3. Mildly prefer case be Enlight or Lian-Li brands. 4. Case should be under $90. 5. Case should be compatible with Asus P4C800-E Deluxe Motherboard which has 1 AGP slot and 5 PCI slots, plus onboard audio, video, and gigabyte lan controller. Board also has Back Panel I/O Ports: 1 x Parallel 1 x PS/2 Mouse 1 x Audio I/O 1 x Serial 1 x S/PDIF Output 4 x USB 2.0/1.1 1 x PS/2 Keyboard 1 x IEEE1394 1 x RJ45 Internal I/O Conn. -2 x USB 2.0 connector support add'l 4 USB 2.0 ports 6. Case should have no power supply or power supply that is easily replaceable. I plan to install power supply of approximately 500 watts. 7. Prefer that case has no fan(s) or fan(s) that are routinely removeable. I prefer to choose and install my own front and rear fans to the inside of the case. Alternatively, if power supply that I choose has a fan, then I'll install one additional case fan. 8. Case should allow front and rear air flow. To quote a magazine article: "Unobstructed air hole in the front of the case for a front-mounted case fan, with some method of air flow from the rear of the case as well". Request brand/model #'s or website references. |
#2
|
|||
|
|||
http://www.lian-li.com/index_1.htm
http://us.enlightcorp.com/ here they are. "Steve Schooler" wrote in message . com... Looking for atx case. Need: 1. 5 or more external 5.25 inch drive bays, 1 or more external 3.5 inch drive bay. Since I always use removeable drive drawers for my "internal" hard disk access, 5.25 inch drive bays must be external. 2. Mildly prefer case height = 20 inches. 3. Mildly prefer case be Enlight or Lian-Li brands. 4. Case should be under $90. 5. Case should be compatible with Asus P4C800-E Deluxe Motherboard which has 1 AGP slot and 5 PCI slots, plus onboard audio, video, and gigabyte lan controller. Board also has Back Panel I/O Ports: 1 x Parallel 1 x PS/2 Mouse 1 x Audio I/O 1 x Serial 1 x S/PDIF Output 4 x USB 2.0/1.1 1 x PS/2 Keyboard 1 x IEEE1394 1 x RJ45 Internal I/O Conn. -2 x USB 2.0 connector support add'l 4 USB 2.0 ports 6. Case should have no power supply or power supply that is easily replaceable. I plan to install power supply of approximately 500 watts. 7. Prefer that case has no fan(s) or fan(s) that are routinely removeable. I prefer to choose and install my own front and rear fans to the inside of the case. Alternatively, if power supply that I choose has a fan, then I'll install one additional case fan. 8. Case should allow front and rear air flow. To quote a magazine article: "Unobstructed air hole in the front of the case for a front-mounted case fan, with some method of air flow from the rear of the case as well". Request brand/model #'s or website references. |
#3
|
|||
|
|||
Steve Schooler wrote:
Looking for atx case. Need: 1. 5 or more external 5.25 inch drive bays, 1 or more external 3.5 inch drive bay. Since I always use removeable drive drawers for my "internal" hard disk access, 5.25 inch drive bays must be external. 2. Mildly prefer case height = 20 inches. 3. Mildly prefer case be Enlight or Lian-Li brands. 4. Case should be under $90. 5. Case should be compatible with Asus P4C800-E Deluxe Motherboard which has 1 AGP slot and 5 PCI slots, plus onboard audio, video, and gigabyte lan controller. Board also has Back Panel I/O Ports: 1 x Parallel 1 x PS/2 Mouse 1 x Audio I/O 1 x Serial 1 x S/PDIF Output 4 x USB 2.0/1.1 1 x PS/2 Keyboard 1 x IEEE1394 1 x RJ45 Internal I/O Conn. -2 x USB 2.0 connector support add'l 4 USB 2.0 ports 6. Case should have no power supply or power supply that is easily replaceable. I plan to install power supply of approximately 500 watts. 7. Prefer that case has no fan(s) or fan(s) that are routinely removeable. I prefer to choose and install my own front and rear fans to the inside of the case. Alternatively, if power supply that I choose has a fan, then I'll install one additional case fan. 8. Case should allow front and rear air flow. To quote a magazine article: "Unobstructed air hole in the front of the case for a front-mounted case fan, with some method of air flow from the rear of the case as well". Request brand/model #'s or website references. http://www.calpc.com/catalog/mid_tower.html |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My Review: ASPIRE Turbo Case X-Dreamer Black Mid-Tower Case with350W Power Supply, Model "ATXB3KLW/350W" | Cyde Weys | General | 3 | June 1st 04 04:10 PM |
current/voltage peak: HD & PD drive dead | ~misfit~ | General | 7 | May 15th 04 08:21 PM |
Mysterious Hard Drive Problem | Bill Anderson | General | 4 | January 18th 04 03:43 AM |
Silent Computer - Advice | David Taylor | General | 49 | October 7th 03 11:26 AM |
Help! WinXP can't tell that my 2nd hard drive is already formatted | FitPhillyGuy | General | 12 | September 26th 03 03:38 AM |