If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Yamaha CR3200S Fails Nero CD-DVD Speed Test- Error No Seek Complete (030200)
I have a Yamaha 3200S Ultra SCSI 24x8x40 CDRW installed with an
Adaptec AHA-2930CU host adapter. I'm also using an Ultra SCSI Pioneer DVD 305 DVD/CD ROM. My system is an AMD Athlon 1700+ on an ECS K7SA Mobo with 1GB of RAM and 4 harddrives. Two 40GB and two 80GB Western Digitials running XP Pro SP1. I've been able to burn CDs with no problems for 2 years. I was using Nero 5.5 to burn. I installed iTunes and noticed some intermittent burns. I uninstalled iTunes then installed Nero 6.6 and to make a long story short (installed, uninstalled and tested with Roxio Easy CD Creator and Sony CD Extreme) I ended up getting some error messages on Nero CD-DVD Speed. The error is NO SEEK COMPLETE (030200). I performed a write test with Nero CD-DVD Speed and it wrote at 24X? Sometimes blank CDs are recognized and sometimes they're not. I originally started with Fujis then bought a spool of Imations thinking it might be a bad batch of disks. The problems persisted. This drive is an IDE or SCSI drive. It ships with a powered adapter that converts the port from IDE to SCSI. I perfomed tests in both modes. I then installed the drive into an AMD K2 450 with about 468MB of RAM running Win2k Server SP4 (a machine I pieced together). The drive was recognized and I get the same errors with Nero CD-DVD Speed on this machine. On this machine the write test passed but at 8X. I have the drive hooked up to the second IDE chain as master. DMA is disabled according to Nero System Info but I cannot activate it. According to the Yamaha manual there should be a Settings tab in Device Manager where DMA mode can be switched on but that tab doesn't exist on either of my machines. Is this something that I can possibly fix? The drive is 2 years old. I sprayed it out a little bit with canned air but haven't attempted to take the cover off to see how it looks inside. TIA, P |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error | kony | General | 6 | October 18th 04 05:38 AM |
Error Correction (WAS: Utility to test IDE cable connections?) | CBFalconer | General | 0 | August 24th 04 04:44 AM |
Modem connection speed | Neil Barnwell | General | 58 | July 14th 04 07:18 PM |
primary slave drive fails (after bug with nero image drive) | Jean | General | 1 | October 8th 03 02:33 PM |