|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 8th 03, 09:39 PM
|
|||
|
|||
What's engineering sample?
I have an ES on my cpu. It's an XP1700 tbred "A".
AXDA1700DLT3C 932521828940 AIRGA 0319XPBW I'm running it at 12.5 x 133 which is the limit of my jumpers. It will not oc with the bios (asus a7v133-c) \o/ Billy 
|
|
#2
November 9th 03, 10:31 AM
|
|||
|
|||
|
"\o/ Billy" wrote
I have an ES on my cpu. It's an XP1700 tbred "A". AXDA1700DLT3C 932521828940 AIRGA 0319XPBW I'm running it at 12.5 x 133 which is the limit of my jumpers. It will not oc with the bios (asus a7v133-c) You should get 8 multipliers more if you cut the rightmost L3-bridge on CPU, but say bye-bye to the warranty...
|
|
#3
November 11th 03, 10:57 PM
|
|||
|
|||
|
Thanks for the tip but I don't want to attempt that.
\o/ Billy You should get 8 multipliers more if you cut the rightmost L3-bridge on CPU, but say bye-bye to the warranty...
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
