If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Booting Problem
I have inherited a pc which seems to have a problem.
When I press the on button, nothing seems to happen. There is no output on the screen. The hard disc seems to start spinning though. When you press the reset button though, after about 7 seconds, it beeps once and then displays the screen which tells you about the bios verson, and that says press DEL to enter setup. IT seems to freeze there. I do not see it counting up the RAM (maybe this happens before the monitor kicks into action), but where the RAM would normally be counted up it shows 'Main Processor: PENTIUM 650MHZ (100MHZx6.5)'. I have tried different RAM, and a new HDD. I have tried this about 10 times and always nothing really seems to happen until you press the reset button. any clues Thanks |
#2
|
|||
|
|||
"*Paul*" wrote in message ... I have inherited a pc which seems to have a problem. When I press the on button, nothing seems to happen. There is no output on the screen. The hard disc seems to start spinning though. When you press the reset button though, after about 7 seconds, it beeps once and then displays the screen which tells you about the bios verson, and that says press DEL to enter setup. IT seems to freeze there. I do not see it counting up the RAM (maybe this happens before the monitor kicks into action), but where the RAM would normally be counted up it shows 'Main Processor: PENTIUM 650MHZ (100MHZx6.5)'. I have tried different RAM, and a new HDD. I have tried this about 10 times and always nothing really seems to happen until you press the reset button. any clues Thanks is the fan spinning on the cpu? Are you loosing power at all? |
#3
|
|||
|
|||
On Tue, 16 Sep 2003 17:56:25 +0000 (UTC), *Paul*
wrote: I have inherited a pc which seems to have a problem. When I press the on button, nothing seems to happen. There is no output on the screen. The hard disc seems to start spinning though. When you press the reset button though, after about 7 seconds, it beeps once and then displays the screen which tells you about the bios verson, and that says press DEL to enter setup. IT seems to freeze there. I do not see it counting up the RAM (maybe this happens before the monitor kicks into action), but where the RAM would normally be counted up it shows 'Main Processor: PENTIUM 650MHZ (100MHZx6.5)'. I have tried different RAM, and a new HDD. I have tried this about 10 times and always nothing really seems to happen until you press the reset button. any clues Thanks Probably the power supply or less likely the motherboard. If you have a voltage meter you might take voltage readings on the power supply ATX connector, though sometimes the voltages look OK when this happens... in other words, if I had tried "everything else" and still couldn't find a problem I'd get a different ~ 250W power supply. Also examine the motherboard for signs of damage including swollen/leaky/vented capacitors. Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMD Problem | Sean | General | 9 | September 17th 03 01:20 AM |
Freezing, lock up, unresponsive problem. | James | General | 5 | September 5th 03 02:54 PM |
Startup/Shutdown Problem | Girgath | General | 5 | August 8th 03 05:45 AM |
Weird CD reading problem | Devang Devani | General | 1 | July 12th 03 03:09 AM |
thinkpad booting problem | Chris Enns | General | 0 | June 26th 03 11:30 PM |