If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Mainboard
"Frank" wrote in
. com: Has anyone been successful installing a standard MicroATX board??? Presario 5000 5WV model. The UWAVE board is a FIC AZ13 with the only apparent change is to the BIOS chip. Compaq/HP wants $179 for a replacement and I can pick up quite a few micro ATX boards for under $50. It would work just fine, of course, but the problem is the location of peripheral jacks on that MB as compared to the Compaq one. The Compaq is non standard, and the holes in the case probably won't match. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about upgrading CPU and Mainboard | Craig Gobbi | Homebuilt PC's | 6 | October 20th 04 02:52 PM |
nvidia mainboard swap | JAD | Homebuilt PC's | 19 | August 23rd 04 05:06 PM |
Problems With An Abit A17 Mainboard | Craig | Homebuilt PC's | 2 | February 4th 04 05:53 PM |
NEWBIE: Case connectors to Mainboard | Wiley Q. Hacker | Homebuilt PC's | 22 | December 9th 03 08:24 PM |
Asking for recommandations on CPU & Mainboard | _Jung | Homebuilt PC's | 7 | September 1st 03 01:45 AM |