If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Adjusting video with monitor and driver
I recently built a new computer, but used the video card from my previous
computer (a 6800NU AGP). After installing XP, I went to adjust the monitor colors using the nvidia driver's adjustment applet, however no matter how I adjust the controls within the driver or the physical controls of my monitor (a high end 21" IBM P260 which was working fine before the computer swap) I simply cannot see the "grey bars" that you are supposed to see when adjusting (I'm running dual monitors and can see them fine in the second monitor). Any ideas why? The monitor looks horrible and I can't get even close to black on it (everything that should be black is just a dark grey). |
#2
|
|||
|
|||
"RobR" wrote in message news:OMtie.6743$_f7.92@trndny01... I recently built a new computer, but used the video card from my previous computer (a 6800NU AGP). After installing XP, I went to adjust the monitor colors using the nvidia driver's adjustment applet, however no matter how I adjust the controls within the driver or the physical controls of my monitor (a high end 21" IBM P260 which was working fine before the computer swap) I simply cannot see the "grey bars" that you are supposed to see when adjusting (I'm running dual monitors and can see them fine in the second monitor). Any ideas why? The monitor looks horrible and I can't get even close to black on it (everything that should be black is just a dark grey). im running 71.89 btw |
#3
|
|||
|
|||
So swap the dual monitors video cables and see if the problem follows a
monitor. Usually you cannot have two active compensation tables. "RobR" wrote in message news:VKFie.7222$_f7.5473@trndny01... "RobR" wrote in message news:OMtie.6743$_f7.92@trndny01... I recently built a new computer, but used the video card from my previous computer (a 6800NU AGP). After installing XP, I went to adjust the monitor colors using the nvidia driver's adjustment applet, however no matter how I adjust the controls within the driver or the physical controls of my monitor (a high end 21" IBM P260 which was working fine before the computer swap) I simply cannot see the "grey bars" that you are supposed to see when adjusting (I'm running dual monitors and can see them fine in the second monitor). Any ideas why? The monitor looks horrible and I can't get even close to black on it (everything that should be black is just a dark grey). im running 71.89 btw |
Thread Tools | |
Display Modes | |
|
|