|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 21st 03, 01:47 PM
|
|||
|
|||
Help! - Datawindow to zebra printer
I have a datawindow with 'Arial' text and a barcode '3 of 9 Barcode'.
I print to a Zebra 220 XiIII Plus printer using a Seagull Zebra ZPL Driver version 6.6.2 There is a pause of 9 seconds between each label. If I download the fonts to the Zebra printer there is no pause. But if I turn the printer off I have to download the fonts all over again. I have saved the fonts to flash, but when the printer is switched off the 'alias' name for the font is lost and the labels are garbled until I download the fonts again. Using different versions of drivers has no effect. Does anyone have any more ideas for troubleshooting? thanks! Tim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
| Problem installing USB printers on Dell 4500 | Paul Filion | Dell Computers | 14 | August 22nd 04 11:51 AM |
| USB Printer Problems | Kevin Altizer | General | 9 | July 24th 04 04:28 PM |
| Dell printer 960 | gringo | Dell Computers | 5 | April 9th 04 07:26 AM |
| Linux to emulate/act as a printer. | Peteris Krumins | General | 0 | December 26th 03 04:22 AM |
Linear Mode
