If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Yes it runs fine on another pc.
G. "Quaoar" wrote in message ... algae wrote: Yes I'm seeing that. However when I switch to the E drive and typ setup.exe I get a "CDR101: Not ready reading drive E. Abort, Retry, Fail." message. Gary "Quaoar" wrote in message ... algae wrote: Not sure about that. I can only assume it was working correctly when I got it. I guess I can take the bottom off the laptop and check it out. G. "Wolfram Nickl" wrote in message y.telekom.at... cdrom correctly installed - cabels? master/slave? When booting from the floppy with CD-ROM support, you should see the installation of the basic ATAPI drivers for the CD-ROM scroll up on the screen. AIRC, the word "OAK" appears on these lines of text. Do you see this text when booting from the floppy? You should boot from the floppy with the installation CD in the drive. After the boot completes, at the command prompt (A:\) type: E:\setup.exe[enter]. Q Does the CD mount OK on another computer? Can you read the files on another computer? Q |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem installing Winmodem on A7N8X-X | Michael Eisenstadt | Asus Motherboards | 2 | November 29th 04 08:51 PM |
Installing 8500DV in New (Home-Built) Sys -- need advice on drivers | [email protected] | Ati Videocards | 7 | June 27th 04 06:25 PM |
Error Installing VIA/S3 Unichrome II KM400 driver XPPro Asus A7V8X-MX SE | Patrick Dunford | Asus Motherboards | 1 | May 14th 04 09:58 PM |
Installing older 43.45 display drivers | Max Harrell | Nvidia Videocards | 8 | December 17th 03 05:53 PM |
installing w98 software on xp | Rick Dancer | Webcams | 0 | July 12th 03 09:24 PM |