|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
7240 MS-DOS Compatibility Mode
Here is some info. In particular in references MS knowledge base article
"DEJ57" wrote in message
Anyone remember the steps to cure DOS compatibility mode operation?
One was to remove the line NOIDE from the regestry, as I recall. Other
two? I believe there was...
I was under the impression this condition sometimes occurs when two IDE
don't get along. A 40GB HDD in my 7204 doesn't appear to be spooning with
Compaq 6x CDROM, or with my BIOS. I used an overlay to get by the 8GB
the 7240 but still have to F1 boot through a HDD error during boot. Since
that's true, that the 7240 doesn't really like the large drive and
may only run in DOS compatibility mode.
|Thread||Thread Starter||Forum||Replies||Last Post|
|nvidia display issues||news.socket.net||Nvidia Videocards||1||March 17th 05 11:57 PM|
|No dma sw mode support for cd writer||ggroups2||Asus Motherboards||1||September 4th 04 01:53 AM|
|my new mobo o/c's great||rockerrock||Overclocking AMD Processors||9||June 30th 04 08:17 PM|
|Protected vs Real||esara||Homebuilt PC's||1||May 1st 04 06:00 AM|
|LINUX 53.28 BAD Performance?||Gizmo||Nvidia Videocards||7||December 31st 03 07:40 PM|