![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() Well I finally found out my chipset the ATI IGP 320M chipset that was in my Compaq Presario 2100 laptop computer. And after quite a bit of searching, I found the ATITool at this location http://www.techpowerup.com/atitool/, which allow some tweaks to core voltage and core frequenzy. But sliding the Core slider did not seem to have any effect. Also there was the "Central Brain Identifier" where I was able to set a lower multiplier, but not a multiplier higher than 13.5 which is the "normal" mulltiplier, and changing the core voltage from 1.45V to 1.5V immediately froze the computer. -- DKDiveDude |
#2
|
|||
|
|||
![]() I am still VERY interested in getting my Compaq Presario faster, as for example put a faster CPU in it. -- DKDiveDude |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Overclocking or upgrading CPU in Presario 2145 | DKDiveDude | Overclocking AMD Processors | 1 | December 29th 04 07:21 PM |
Looking for some medium-to-extreme overclocking advice | Cyde Weys | General | 4 | July 2nd 04 04:03 AM |
Opinion needed on new AMD system and overclocking ability | Bill | Overclocking AMD Processors | 11 | November 21st 03 06:15 PM |
First Time Overclocking Results | uncooked meat prior to state vector collapse | Overclocking | 3 | August 30th 03 02:36 PM |
OverClocking Guides | Phil Weldon | Overclocking | 0 | August 15th 03 05:41 AM |