A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Video Cards » Nvidia Videocards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

creative 5900 ultra windows only see 128 mb



 
 
Thread Tools Display Modes
  #1  
Old August 21st 03, 08:05 PM
Lasse
external usenet poster
 
Posts: n/a
Default creative 5900 ultra windows only see 128 mb

got my self a present a creative 5900 ultra. which should be a nice upgrade
from a ti4200

and then the problems started:

i uninstalled the ti4200 and driver, and put in the 5900U into the
system..and installed the latest driver of that time the 44.03

then dxdiags only found 128 mb while the geforce tab in the display setting
showed 256 mb, gunmetal ran at 1024x768 32 bit 4xAA at around 7-9 fps way to
low.

i reinstalled w2k pro, and dxdiags(9b) finally found 256 mb and gunmetal ran
just fine with 29 fps at the same settings as above.

now 20 reboots later the system again only finds 128 mb and gunmetal is back
to 9 fps, i dont get it, i havent changed anything during those 20 reboots
(about 14 days of use)

i tried reinstalling driver, removing card, inserting it agin...use
detonator r.i.p. loaded 45.23 drivers...no luck only 9 fps

what can i do to make the system recognize the videocard correctly, or
rather recognise all 256 mb?(i really dont wanna reinstall again after only
14 days)

my system is as follows:
asus p4c800 2.8 ghz 800 fsb 1gb hyperx 3500 cl2 ram
4xwesterndigital 120gb disks on promise sx4000 raid controller raid 0
audigy2
antec truepower 550
asetec waterchill cools the whole thing (vga, nb, cpu) and temps dont over
40 C under load (vga/cpu)
w2k is totally up to date no missing updates (including directx)


  #2  
Old August 22nd 03, 01:59 AM
Timothy Drouillard
external usenet poster
 
Posts: n/a
Default

OK, stupid question time.

A true 5900 Ultra will have a 4-pin molex connector on the rear edge of the
video card. you MUST connect a power cable from the PS to this connector in
order to use it's full capabilities.

If you don't plug a power cable into it, it will run as reduced horsepower.
But it should also display an error message telling you to plus a power
cable in.

can you tell if the video card fan is working?

It may also be a bad video card.
"Lasse" wrote in message
...
got my self a present a creative 5900 ultra. which should be a nice

upgrade
from a ti4200

and then the problems started:

i uninstalled the ti4200 and driver, and put in the 5900U into the
system..and installed the latest driver of that time the 44.03

then dxdiags only found 128 mb while the geforce tab in the display

setting
showed 256 mb, gunmetal ran at 1024x768 32 bit 4xAA at around 7-9 fps way

to
low.

i reinstalled w2k pro, and dxdiags(9b) finally found 256 mb and gunmetal

ran
just fine with 29 fps at the same settings as above.

now 20 reboots later the system again only finds 128 mb and gunmetal is

back
to 9 fps, i dont get it, i havent changed anything during those 20 reboots
(about 14 days of use)

i tried reinstalling driver, removing card, inserting it agin...use
detonator r.i.p. loaded 45.23 drivers...no luck only 9 fps

what can i do to make the system recognize the videocard correctly, or
rather recognise all 256 mb?(i really dont wanna reinstall again after

only
14 days)

my system is as follows:
asus p4c800 2.8 ghz 800 fsb 1gb hyperx 3500 cl2 ram
4xwesterndigital 120gb disks on promise sx4000 raid controller raid 0
audigy2
antec truepower 550
asetec waterchill cools the whole thing (vga, nb, cpu) and temps dont over
40 C under load (vga/cpu)
w2k is totally up to date no missing updates (including directx)




  #3  
Old August 22nd 03, 02:27 AM
Athura
external usenet poster
 
Posts: n/a
Default

reinstalled motherboard drivers?
bios update maybe?


  #4  
Old August 22nd 03, 10:25 AM
Lasse
external usenet poster
 
Posts: n/a
Default

the power cable is plugged into the card, as i mentioned the card has been
running just fine, until yesterday.

on boot it always shows 256 mb, and the geforce tab allways shows 256 mb

only dxdiags and the adaptertab in display properties reveal that there is
something wrong.

the card is watercooled...and i have removed the fan as it made alot of
noise, can it be that the card needs this fan to run properly ? then i need
to figure out how to make a fan emulator as i dont want the noise it is
creating.


Lasse


  #5  
Old August 22nd 03, 10:29 AM
Lasse
external usenet poster
 
Posts: n/a
Default

ohh and the bios for the motherboard is the newest, same goes for raid
controller, i havent been able to find a new bios for the gf5 card.

all drivers are newest too, i keep my os in top nothc when concerning
updates

Lasse


  #6  
Old August 22nd 03, 01:30 PM
Lasse
external usenet poster
 
Posts: n/a
Default

with out touching anything inside the computer, i reinstalled win2k on an
old disk and that works fine all 256 mb found, and games runs great.

but so did my main system...14 days ago....until yesterday where it ****ed
up for no reason

Lasse


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
pc problems after g card upgrade + sp2 ben reed Homebuilt PC's 9 November 30th 04 01:04 AM
Freedom: Coming to a Windows Box Near You Ablang General 0 June 30th 04 03:04 AM
Please help with new system - hangs when booting Windows 2000. Kevin Lawton Homebuilt PC's 7 April 14th 04 02:40 AM
Do I need Windows XP? Red Cloud Homebuilt PC's 8 December 27th 03 02:04 AM
Does Windows kill the "bootability" other secondary hard drives it finds with the same OS on? Kb General 3 September 5th 03 12:33 PM


All times are GMT +1. The time now is 08:52 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.