If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clicking sound from speakers
Recently moved my computer. Have an Altec Lansing 5.1 speaker system
with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ |
#2
|
|||
|
|||
On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk
wrote: Recently moved my computer. Have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ It's probably due to high-drain devices on your home AC circuit, not the PC itself, assuming no hardware, driver or bios changes. If that is the case then the solution is to use a different AC circuit or use a line conditioner (or better UPS with one built-in). |
#3
|
|||
|
|||
On Mon, 25 Oct 2004 03:20:19 GMT, kony wrote:
On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: Recently moved my computer. Have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ It's probably due to high-drain devices on your home AC circuit, not the PC itself, assuming no hardware, driver or bios changes. If that is the case then the solution is to use a different AC circuit or use a line conditioner (or better UPS with one built-in). Except that nothing has changed power-wise. Same plug, same devices. possible in the reconfiguration I changed what goes where in terms of power strips. |
#4
|
|||
|
|||
In message
kony wrote: On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: Recently moved my computer. Have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ It's probably due to high-drain devices on your home AC circuit, not the PC itself, assuming no hardware, driver or bios changes. If that is the case then the solution is to use a different AC circuit or use a line conditioner (or better UPS with one built-in). The other possibility is that you have routed an AC lead from an electrically grotty switching power supply parallel to your speaker signal lead. Yet another possibility is that you have placed your speakers near a very noisy source. The simplest way to check is this is the case is to make sure the signal cable connecting the computer to the speakers is routed well away from power cables and make sure that the speakers are not too close (6") to a heavy noise source (eg AC cable, computer supply, old o'scope etc). -- Chris |
#5
|
|||
|
|||
Chris Ballance wrote in message ...
In message kony wrote: On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: Recently moved my computer. Have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ It's probably due to high-drain devices on your home AC circuit, not the PC itself, assuming no hardware, driver or bios changes. If that is the case then the solution is to use a different AC circuit or use a line conditioner (or better UPS with one built-in). The other possibility is that you have routed an AC lead from an electrically grotty switching power supply parallel to your speaker signal lead. Yet another possibility is that you have placed your speakers near a very noisy source. The simplest way to check is this is the case is to make sure the signal cable connecting the computer to the speakers is routed well away from power cables and make sure that the speakers are not too close (6") to a heavy noise source (eg AC cable, computer supply, old o'scope etc). -- Chris Had similar problem it was due to bad shielding in the speakers themselves. They would pick up CB traffic from Tractor-trailers and Taxis on the street making the sound crackle and pop Darren |
#6
|
|||
|
|||
|
#7
|
|||
|
|||
"Air Force Jayhawk" wrote in message
... On 25 Oct 2004 11:31:47 -0700, (Gimmyagame) wrote: Chris Ballance wrote in message ... In message kony wrote: On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: Recently moved my computer. Have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the computer, which required disconnecting, rerouting, and reconnecting every wire and cable, I have a very annoying clicking sound from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. Before I pull everything apart...any ideas? AFJ It's probably due to high-drain devices on your home AC circuit, not the PC itself, assuming no hardware, driver or bios changes. If that is the case then the solution is to use a different AC circuit or use a line conditioner (or better UPS with one built-in). The other possibility is that you have routed an AC lead from an electrically grotty switching power supply parallel to your speaker signal lead. Yet another possibility is that you have placed your speakers near a very noisy source. The simplest way to check is this is the case is to make sure the signal cable connecting the computer to the speakers is routed well away from power cables and make sure that the speakers are not too close (6") to a heavy noise source (eg AC cable, computer supply, old o'scope etc). -- Chris Had similar problem it was due to bad shielding in the speakers themselves. They would pick up CB traffic from Tractor-trailers and Taxis on the street making the sound crackle and pop Darren Except that the clicking started with the reconfiguration...was fine before. It's a far stretch, but wireless router/access point?? (it was for my low end speakers) i just had to move it. |
#8
|
|||
|
|||
On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk
wrote: I recently moved my computer into a new desk. I have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the system (which required disconnecting, rerouting, and reconnecting every wire and cable), I have a very annoying low frequency as well as occasional clicks and other random noises from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. I would be sure it was power related except that it comes and goes based on what is being displayed. For example the hum becomes much more noticeable with the 3D Windows XP screen saver up. Also, when a window is being dragged around the screen I hear another buzz, although higher frequency this time. Thinking it might be the monitor, I turned it off. No fix. Then I disconnected the video cable...again, no improvement. Just today I installed a UPS. One, I felt I needed one, but I had hoped that the buzz would go away either by the UPS or by the fact the lines would be all pulled apart and reconnected, possibly by chance separating the troublesome cables. No luck. Please note it was fine before...so environmental issues like neighbors phones are not a player. It has been suggested earlier that it might be my wireless router (it is closer to a speaker than it was before) but again I point to the fact that the sound intensity varies based on the screen display but does NOT change when I disconnect the monitor. Could they still be related??? Any other ideas? This is driving me absolutely nuts! AFJ |
#9
|
|||
|
|||
"Air Force Jayhawk" wrote in message ...
On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: I recently moved my computer into a new desk. I have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the system (which required disconnecting, rerouting, and reconnecting every wire and cable), I have a very annoying low frequency as well as occasional clicks and other random noises from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. I would be sure it was power related except that it comes and goes based on what is being displayed. For example the hum becomes much more noticeable with the 3D Windows XP screen saver up. Also, when a window is being dragged around the screen I hear another buzz, although higher frequency this time. Thinking it might be the monitor, I turned it off. No fix. Then I disconnected the video cable...again, no improvement. Just today I installed a UPS. One, I felt I needed one, but I had hoped that the buzz would go away either by the UPS or by the fact the lines would be all pulled apart and reconnected, possibly by chance separating the troublesome cables. No luck. Please note it was fine before...so environmental issues like neighbors phones are not a player. It has been suggested earlier that it might be my wireless router (it is closer to a speaker than it was before) but again I point to the fact that the sound intensity varies based on the screen display but does NOT change when I disconnect the monitor. Could they still be related??? Any other ideas? This is driving me absolutely nuts! AFJ Go into the control panel (mixer) for your sound card and try muting the inputs one by one to see if one of them makes the sound go away. If you have an analog audio cable connected from your CD or DVD player, try disconnecting that, and if that helps try rerouting the cable. |
#10
|
|||
|
|||
move the power cords to another circuit. You may be on the same as the
Heater/Ac or washer and dryer...the timers for these appliances can cause clicks. "Air Force Jayhawk" wrote in message ... On Sun, 24 Oct 2004 19:46:31 -0400, Air Force Jayhawk wrote: I recently moved my computer into a new desk. I have an Altec Lansing 5.1 speaker system with a Soyo motherboard with imbedded 5.1 sound adapter. Ever since I moved the system (which required disconnecting, rerouting, and reconnecting every wire and cable), I have a very annoying low frequency as well as occasional clicks and other random noises from the speakers. I have ensured all of the connections into the subwoofer are solid but that didn't fix it. I would be sure it was power related except that it comes and goes based on what is being displayed. For example the hum becomes much more noticeable with the 3D Windows XP screen saver up. Also, when a window is being dragged around the screen I hear another buzz, although higher frequency this time. Thinking it might be the monitor, I turned it off. No fix. Then I disconnected the video cable...again, no improvement. Just today I installed a UPS. One, I felt I needed one, but I had hoped that the buzz would go away either by the UPS or by the fact the lines would be all pulled apart and reconnected, possibly by chance separating the troublesome cables. No luck. Please note it was fine before...so environmental issues like neighbors phones are not a player. It has been suggested earlier that it might be my wireless router (it is closer to a speaker than it was before) but again I point to the fact that the sound intensity varies based on the screen display but does NOT change when I disconnect the monitor. Could they still be related??? Any other ideas? This is driving me absolutely nuts! AFJ |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Surround sound speakers for pc and dvd | RJJ | Homebuilt PC's | 1 | July 17th 04 05:27 PM |
Laptop makes clicking sound | code_wrong | General | 4 | May 9th 04 10:13 PM |
Clicking Sound From Hard Drive | NoSpam | General | 1 | April 9th 04 01:04 PM |
What could cause Sound output to suddenly go nearly silent? | kevins_news | Homebuilt PC's | 19 | December 1st 03 03:09 PM |
2 Sound cards - 1 pair of speakers | Ps | Homebuilt PC's | 4 | July 5th 03 09:55 PM |