If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
problem with new cd/dvd burner
I recently installed a new cd/dvd burner. Everything seemed fine. I
didn't realize until I gave a CD to somebody else that it did not finalize the CD. When burning CDs, I have always used windows explorer to drag the files onto the CD and then write CDs. It worked fine with the old burner. Is there a setting I need to change? I looked at the properties for the CD drive, and didn't say anything about finalizing a CD. Thank you very much. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DVD burner problem | ole | Dell Computers | 0 | February 9th 08 12:06 PM |
DVD Burner Problem | Morton | Cdr | 3 | September 6th 07 05:01 AM |
Burner problem | Beowulfie | Compaq Computers | 3 | April 8th 05 03:13 AM |
cd burner problem | Eric | Storage (alternative) | 1 | February 6th 05 10:41 PM |
cd burner problem | Eric | General | 0 | February 6th 05 02:40 PM |