If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help on Tape LBA
Hello everyone...
Just some follow-up questions on Malc's answers to my previous questions... Since data are stored sequentially, so the block positioning are also sequential, right? How can we identify an end of the block, especially if a single cartridge contains blocks of different sizes? Is this where filemarks come in? Once again, thank you so much for your help. ^-^ - shiera - |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DLT internal tape in DL530 | John | Compaq Servers | 4 | February 4th 05 10:12 PM |
Tape LBA vs. HDD LBA | Shiera | Storage & Hardrives | 2 | December 25th 03 03:17 PM |
Making a pure IDE/ATAPI tape drive work in a USB drive enclosure. (0/1) | Bloke at the pennine puddle (Replace n.a.v.d with | General | 0 | October 11th 03 05:02 PM |
exabyte vxa-2 tape drive error | Lynn McGuire | Storage & Hardrives | 4 | September 16th 03 07:56 AM |
Tape Erase or format request | Howard Huntley | Storage & Hardrives | 1 | September 5th 03 03:48 PM |