If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
In article ,
David Lewis wrote: | Hi , I'm a relative Newbie so please keep it simple...why did you choose non | Raid in such a high end system (is SATA superior?) Apart from cost (?)..Why | not SCSI ? Why not dual processors (is HT just as good?) Starting with RAID: RAID-0 (striped) is a performance thing, it spreads the head motion over multiple drives and increases the effective bandwidth by sending multiple data streams to/drom memory (assuming your bus can keepup, of course). RAID-1 (mirror) gives a copy in case of a disk error, and a good implementation allows reading data from any copy, while writing to every copy. On an application which has few writes and many reads this can really help server performance. You have (at least) two copies of the data, more are possible. Performance in case of failure is somewhat better, you have a copy available with a single read, not multiple reads and a bunch of math. RAID-5 (striped with a distributed checksum) gives much of the throughput benefit of RAID-0 and with run in degraded mode if a single drive fails. This is usually faster than RAID-1 and cheaper as well, since you don't need twice as much disk as data. There are many possibilities, you can stripe across mirrored sets, or mirror several striped sets. This is usually called RAID-0+1, or incorrectly RAID-10, which is actually a trademark of Storage Computer Systems in NH (I have used some of their hardware). The other RAID levels I left out belong in a tutorial rather than an introduction, they are rarely used. Software RAID - some operating systems, notably Linux, allow the RAID to be done in/by the system CPU instead of the controller. If a drive fails while you are trying to boot that's bad. Otherwise it's neat, because you can stripe and/or mirror individual partitions, so I can take for instance 4GB of each drive for a mirror, put my best data there, and use the rest of the drives without RAID. Or you can mix RAID types for really odd application loads (does it). I believe Sun partition manager (Solaris) can do this, it certainly can do RAID on whole drives. HT va. SMP: With SMP you get cache on each CPU, and two paths to memory for bandwidth, with the right application you can get about 90% boost from the 2nd CPU. That's with real applications, not benchmarks. With HT you have contention for cache and FPU, and one path to memory. If you are running threads of a single process you gain because all the mutexes are in cache and don't GO to memory at all. With the right application you can get 20-30% gain from HT. I have seen benchmarks do better, but never "real stuff." BUT... Win2k doesn't handle HT quite right, and I have yet to have someone other than MS that Server2003 does or doesn't. Linux recent 2.4 kernels do a pretty good job, and the 2.5 test kernels do a significantly better job. HT doesn't look exactly like a 2nd CPU, so the scheduler needs to be careful. Hope this is useful rather than "more than I wanted to know" for you, it should help you follow the discussions here and elsewhere, and recognise bull**** when people make sweeping statements. -- Bill Davidsen CTO, TMR Associates As we enjoy great advantages from inventions of others, we should be glad of an opportunity to serve others by any invention of ours; and this we should do freely and generously. -Benjamin Franklin (who would have liked open source) |
#22
|
|||
|
|||
bill davidsen wrote:
Snipped most of reply Hope this is useful rather than "more than I wanted to know" for you, it should help you follow the discussions here and elsewhere, and recognise bull**** when people make sweeping statements. Bill,just returned from holiday and saw your reply.Many thanks for providing a detailed and excellent summary which helps tie together some of these more advanced technologies.It's sometimes difficult for newbies to get a handle on things when discussed in relative isolation to the broader picture.I will be looking out for your replies in future!Once again,thanks -- Kind Regards, David |
#23
|
|||
|
|||
There are many possibilities, you can stripe across mirrored sets, or
mirror several striped sets. This is usually called RAID-0+1, or incorrectly RAID-10, which is actually a trademark of Storage Computer Systems in NH (I have used some of their hardware). Dell lists it as Raid-10...hehe Seems logical to me to name it that way.... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Intel found to be abusing market power in Japan | chrisv | General | 152 | March 26th 05 06:57 AM |
Intel Is Aiming at Living Rooms in Marketing Its Latest Chip | Vince McGowan | Dell Computers | 0 | June 18th 04 03:10 PM |
Questions 875PBZ Intel Board | SRobert | Homebuilt PC's | 1 | October 6th 03 02:10 PM |
Best bang for buck CPU? | Shawk | Homebuilt PC's | 9 | October 5th 03 07:24 PM |
Intel 875PBZ BIOS freeze | Adrian | General | 4 | July 4th 03 04:13 AM |