A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals » Printers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Zebra TLP 2844



 
 
Thread Tools Display Modes
  #1  
Old April 5th 07, 07:33 PM posted to comp.periphs.printers
Miticologo
external usenet poster
 
Posts: 2
Default Zebra TLP 2844

I have a problem printing labels with a Zebra TLP2844.
In VS2005 C# I wrote these few lines using "Waterfurnace.ZebraPrint" library

zPrint.StartWrite(System.Configuration.Configurati onManager.AppSettings["PrinterPath"]);
zPrint.Write("N");
zPrint.Write("A220,300,0,4,1,1,N,\"TEST\"");
zPrint.Write("B220,120,0,E30,3,20,100,B,\"" + strBarcode + "\"");
zPrint.Write("P1");
zPrint.EndWrite();


It works quite well, the problem is that before and after the label, it
prints a blank label (the sequence is "blank label"-"correct label"-"blank
label").
Where is the error?
Thank you in advance
Daniele



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Zebra ZPL help [email protected] Printers 1 March 21st 06 03:36 PM
Zebra Z6M Plus Printer Melanie Foster Printers 2 August 27th 04 04:12 PM
Zebra TLP 2844 Eitan Printers 2 February 5th 04 09:55 AM
WTB: Zebra 2844 logic board LB Printers 0 October 3rd 03 06:02 AM
Zebra 2844 UPS firmware needed Lee B. Printers 0 September 25th 03 12:32 AM


All times are GMT +1. The time now is 03:49 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.