A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors » Overclocking AMD Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Overclocking or upgrading CPU in Presario 2145

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old January 2nd 05, 09:06 PM
external usenet poster
Posts: n/a
Default Overclocking or upgrading CPU in Presario 2145

Well I finally found out my chipset the ATI IGP 320M chipset that was in
my Compaq Presario 2100 laptop computer.

And after quite a bit of searching, I found the ATITool at this
location http://www.techpowerup.com/atitool/, which allow some tweaks
to core voltage and core frequenzy. But sliding the Core slider did not
seem to have any effect.

Also there was the "Central Brain Identifier" where I was able to set a
lower multiplier, but not a multiplier higher than 13.5 which is the
"normal" mulltiplier, and changing the core voltage from 1.45V to 1.5V
immediately froze the computer.


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Overclocking or upgrading CPU in Presario 2145 DKDiveDude Overclocking AMD Processors 1 December 29th 04 08:21 PM
Looking for some medium-to-extreme overclocking advice Cyde Weys General 4 July 2nd 04 04:03 AM
Opinion needed on new AMD system and overclocking ability Bill Overclocking AMD Processors 11 November 21st 03 07:15 PM
First Time Overclocking Results uncooked meat prior to state vector collapse Overclocking 3 August 30th 03 02:36 PM
OverClocking Guides Phil Weldon Overclocking 0 August 15th 03 05:41 AM

All times are GMT +1. The time now is 04:26 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2004-2024 HardwareBanter.
The comments are property of their posters.