Hi,

The unarj.bat is simple:
******start******
c:\
md bu
y:\ REM Where Y: is the CD's drive
cd\dosmenu
arj x -y -r -i1 y:\bu\d\d.arj c:\
arj x -y -r -i1 y:\bu\e\e.arj c:\
arj x -y -r -i1 y:\bu\f\f.arj c:\
arj x -y -r -i1 y:\bu\h\h.arj c:\
arj x -y -r -i1 y:\bu\i\i.arj c:\
arj x -y -r -i1 y:\bu\j\j.arj c:\
arj x -y -r -i1 y:\bu\k\k.arj c:\
arj x -y -r -i1 y:\bu\l\l.arj c:\
arj x -y -r -i1 y:\bu\m\m.arj c:\
arj x -y -r -i1 y:\bu\n\n.arj c:\
arj x -y -r -i1 y:\bu\o\o.arj c:\
arj x -y -r -i1 y:\bu\p\p.arj c:\
arj x -y -r -i1 y:\bu\q\q.arj c:\
arj x -y -r -i1 y:\bu\r\r.arj c:\
********end*******

But, you are right. My restore disk was for Win95. If yours is for
win3.11, they may be different.

Rock


"SonicClub" wrote in message
lkaboutcomputing.com...
Well, thanks for trying to help, it seemed so promising. The restore CD I
was asking about has the BU folder, but not the DOSMENU folder. The
restore floppy that goes with the CD has Arj.exe, but not Unarj.bat, I
have a restore disc that went to my second Packard Bell PC that was made
in 1998, but even that CD didn't fully match this tutorial you posted. My
newer Packard Bell's restore CD has the DOSMENU folder, but also no BU
folder and no Arj.exe, or Unarj.bat. I'll still try to use your advice to
try to help me use the restore CD's unless you got some other information.
By the way, the restore CD I was asking about had Windows 3.11, so I am
guessing my restore disc must be a little older than yours so maybe a few
other things need to be done, maybe a different way of using the restore
disc, I don't know, got any ideas? Anyway, I appreciate your reply, that
info may end up helping with something, I may just have to figure out what
needs to be done differently, i'm sure using this restore CD couldn't be
too much different than yours, they seem like they're pretty close to the
same time. If you or anyone else has any more help, feel free to post.
Thanks.