View Single Post
  #7  
Old January 30th 05, 03:16 AM
Tanya
external usenet poster
 
Posts: n/a
Default

snip
here are the corrected psu readings (from the manual)
(the voltages in (...) are the specified ranges)

(they are referred to as 1-12 although there are 2 separate connectors into
the board)
1 = power good (5.00 v)
2 = 5.04 (3.75-6.25)
3 = 11.71 (9 - 15)
4 = - 11.87 (-9 to - 15)
5 , 6, 7 (grounds) but are -0.00
8 = (ground) 0.00
9 = -5.01 (-3.75 to - 6.25)
10, 11, 12 = 5.01 (3.75 to 6.25)

the hd connector
1 = 11.71 (12 volts)
2 and 3 are grounds)
4 = 5 (5 volts)
(both connectors were equal)
i CANNOT test the power to the media console controller card... not even
sure how to remove it -- (since it has the power switch, the a-drive and
floppy drive) it is sort of square (however the manual has wire 1 as 5
volts and wire 4 as 12 volts)
any suggestions?
thanks
sincerely
Tanya