ati AIW 9600 - connecting tv coax cable to ATI (HOW)?
Thanks,
I found out what the problem was.
I was trying to scan for channels thru the vcr, dvr, and cable box.
with no luck.
I needed to connect the "raw" cable (no devices on the wire) to the
card first then scan for channels, once it found the channels, I then
was able to connect the card to the DVR and see the signal for the DVR
and VCR.
T Shadow wrote:
"tdr" wrote in message
ups.com...
I can not find any info on how to connect the cable companies coax to
the ati 9600 AIW and watch tv. (or record from the cable companies DVR
- device is 30+ feet away from the computer)
What is the tv connector? input? or Output?
Do I need another device to convert the coax to s-video or composit?
I was able to get an ext. dvd player connected but that was thru the
composit ports.
TIA.
Connectors are described in MMC*.PDF on the disc that came with your AIW.
Basically the RF co-ax connector and the breakout box are input. Everything
else is output.
I have cable run directly to the co-ax connector for easy access to standard
channels. Have S-Video&audio from the box to the breakout box for the best
picture from the box and the RF out of the box is not stereo.
50ft S-Video cables are available. May need an amplifier. If you wanted to
connect both the cable box and DVR to the AIW this way you'll have to get a
S-Video & audio switch. The switch would make it more likely to need an
amplifier. It's possible they make a switch/amplifier combo.
Hope I understood your post correctly and this helps.
|