"Rob Thompson" wrote in message
...
I have a GA-7VAX with a Barton 2500, 512 PC2700, working fine @ 1827mhz
and
smooth performance. I want to bump up performance a little but aren't
sure
exactly what to do. In the BIOS for freq/volt control when I change the
FSB
freq I get a box that says ,is this
just asking to raise the FSB freq? The pci/agp is at 33/66, dram at 166,
ddr 333. My MB switches are set for auto, and Eazytune 4 reports my
multiplier locked at 11. I've read ET4 sucks and to use the BIOS instead,
is that correct?

--
Rob Thompson


That board is a great stable board, but when you raise the FSB it also
raises the PCI and AGP buses. Sooo, you are going to be limited to what your
Video card or memory or any other PCI devices you have attached can take in
the way of over clocking.
Best way to overclock on that board is to raise the Multiplier if you are
lucky enough to have an unlocked CPU. Otherwise you need an nForce board or
one that locks the busses while allowing the FSB to change.
Yes, 'key in a DEC number, min 166 max 250' is the FSB setting.