the 'proper' way is to use the console.......not to say that what you
do doesn't work. Question: after doing the install your way, have you
looked over the boot log? is it without 'failed to load' lines,
curious is all.


"spodosaurus" wrote in message
...
maurice wrote:
Ok, two very different opinions here,

JAD "1. after the install of the MB boot with XP CD and do a
repair
install
from the console"


You dont want to go into the console. Just put the hardware
together,
and boot from the XP cdrom. Keep going through the stages as if you
were
going to do a new install. Eventually you'll be asked if you want to
reinstall or repair (not the same as console), and this is what you
want. If you miss it, do NOT format anything :-)

DaveW "2. Unless you replace the motherboard with the EXACT SAME
MOTHERBOARD,
including version, etc., you'll be hosed if you don not reformat
the
harddrive and do a CLEAN install of the OS"


Dave is talking out of his arse, this is not the only way.

Dave, have you had first hand experience with swapping identical
chipset
boards and having to reformat. Do you have reason to believe the
repair
console wont work?

I normally would reformat but the client has had some custom
software
installed which will need to be reconfigured by the vendor if I
have to
reinstall the OS.

Anybody else had good or bad luck with either of these scenarios?


I've done both, both work.

thanks



"maurice" wrote in
message
.au...

I have have to replace a nvidia chipset mainboard a gigabyte
ga7n400,

with

another mainboard but really dont want to have to do a reinstall
of XP.
Ideally Id replace with the same model but its a very tight
budget (and

a

very long story!) so I was looking at using another Gigabyte
nforce

chipset

board either the ga7n400L or a new model ga7nf-rz which I can
find no

info

on beyond it uses mcp and spp.

I know the sound will be different(the pro uses the nvidia
soundstorm

chip)

but hopefully this wont be a terminal
problem, its differences in the different flavors of the nforce
chipset

I'm

most concerned about. I was hoping that the core logic for ide
drives

etc

would be close enough not to cause a problem but if the past
history of

this

job has any bearing then I'm screwed!

any thoughts on these issues much appreciated

cheers

Maurice








--
spammage trappage: replace fishies_ with yahoo