On Wed, 23 Jul 2003 12:26:09 -0400, "Ric" wrote:

Have you ever been able to burn faster? Have you changed your media type?
There are clearly media compatibility differences between different firmware
versions, so I suggest you download 6S0D from their website
...

Ric: In my case, I was able to burn 200 meg at 32x (That is what Nero
suggested) back in April. I did a couple of (multi) sessions where I added
typically 20Meg. But the latest session resulted in errors. No changes were
made to the firmware nor software, and it is the same disk as I started with,
a CD-R Maxell, certified at 40x. I tried a TDK disk (unknown rating: It says
Certified on the disk) at 32x, it failed. Then a blank K Hypermedia disk,
rated 48X, but I ran it at 24X it failed. I got a couple of good burns using
12x on cd-r. It worked OK at 24x on a R/W disk.

I am using Windows 95 on this machine. The hard drive is plugged into the 1st
connector (Master) on the 40 pin Primary IDE cable. The cd drive is in the 2nd
connector (slave) of the same cable. DMA is turned off, and has been off since
February, when I was trying to get inCD or packet to work. I gave up on that.

-----------

Remove "not" for return address.