"Rick B." wrote in message
om...

Thanks for all the followup, I did try using different drives in
different bays before I posted this message. It made no difference
whatsoever which bay the drives were physically located, the
configuration utility always reported the exact same status for the
drives in question. I'll check the backplane and all the cable
connections, if that fails I guess I'll ghost it and blow it away.
Fortunately the server is not yet in full production, thus giving me a
little wiggle room to do this.




Good luck. One suggestion is that you might also want to do a full backup
using your backup/tape utility to be 100% sure that you have some redundancy
before you proceed. I was never fully confident with Ghost.



Rita