yep.
close the laptop, remove the 3 screws on the back,at the base of the lcd .
then open the laptop, and carefully, near the right hand side, remove the
cover,the one that the 3 screws were in. use a plastic knife or credit card,
and gently pop off the little cover. (your power buttons etc are on this
cover).then, remove the little rubber dots on the lcd trim, these are screw
hole covers, put them somewhere safe(i used a pill bottle)you will need
these to plug the screw holes back up.remove the screws now again use a
credit card, remove the bezel trim from the lcd .after that, you will see
the invertor, gently disco both ends of the lcd and the cable that aatches
to the base(it will be a little cable near where the acer logo was on the
cover you removed.)remove the screws on opposite ends of the hinges.you'll
also see 4 mounting screws that attach the lcd to the laptop lid.when you
remove the old lcd,hold it near the base,same when replacing the new
one.once you get the first few steps done, its easy to see how it
dissasembles.


"Louie" wrote in message
.. .
Does anyone know how or can point me in the right direction? Have to
replace LCD. Thanks!

Louie