Same for 3550 and 3555, 3020 and 3060. And 4090US. One HD and one CD-ROM
only. No space or connectors for more
HH
"Mike Calkins" wrote in message
...
Dale, there were a few Presarios that supported very few IDE devices.
The Presario 425 / 433 and 460 supported only one IDE HDD and no IDE
CD-ROM.
The Presario 520, 524, 526, 5526 and 5528 supported one IDE HDD and one
IDE
CD-ROM. (and had no space or power connectors for additional drives).
"DEJ57" wrote in message
...
I have a few Compaq laptops that I'd love to see you pull this trick
on.
Even a few Presario desktops that only supported one HD as shipped from
Compaq.
We weren't talking about laptops. Different animal, for the most part.
Both my 4112 and 7240 shipped with only a two connector data on the
first
channal and the second channal. To add additional HDDs, I HAD TO USE
STANDARD
DATA CABLES--no SCSI data cables were easily available retail in my
area.
Could have special ordered them or had them made, I suppose, but for
what
reason?
I would argue against describing these Presarios as only supporting one
HDD as
shipped from Compaq (I have had a 386 and several 486 Compaq laptops
that
support four IDE with a little bit of effort, and that Compaq will tell
you
can't be done--"its not supported") Compaq was simply too cheap to
supply
three connector data cables on both the channels, nor did they want the
excess
cable stuffed into the boxes, I'd bet. On the systemboard of the 4112
they
were too cheap to include the sockets for additional RAM chips as well
as
the
socket for upgrade video memory. But the solder points and board space
for
those sockets were there. But back to the HDDs--if you happened to have
CS
three connector data cables, these Presarios would support four CS
jumpered IDE
devices fine--and they would also support four IDE devices using
standard
three
connector data cables just as well, jumpered as Master and Slave,
appropriately. The systemboard didn't care.
The "support" was there, just not the necessary number of connectors on
the
data cables. One just used the new three position data cable that comes
with
most new HDDs. But the included cables have never been CS, in my
experience.
Compaq 's going against the grain in using CS sure has been the source
of
much
confusion and many questions in support forums for Compaq.
Dale
|