I would like to know now how to pin out my audio from the case as
follows:

Cable from case:

Black = Ground
Red 2 = Mic in
yellow 2 = mic-power
white 2 = R-ret
yellow 1 = R-out
white 1 = L-out
red 1 = L-ret

On the motherboard as follows:
Azalia Compliant pin definition:

-------------------------------------------------------------------------------------------------------------------------------------------------------
Top pins, L to R: GND, | Presence#, |
Sense1_RETUR, | (pin missing), |
Sense2_RETUR
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Bottom, L to R: Port1-L, | Port1-R, | Port2-
R, | Sense_Send |
Port2-L

----------------------------------------------------------------------------------------------------------------------------------------------------------


for the Legacy AC'97 Compliant pin definition:

Top Pins, L to R:
_

-------------------------------------------------------------------------------------------------------------------------------------------------------
Top pins, L to R: AGND | NC |
NC | (pin missing), | NC
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Bottom, L to R: MIC2 | | MIC PWR | Line Out-
R, | NC | Line-Out-L

----------------------------------------------------------------------------------------------------------------------------------------------------------


I hope my ascii diagarm doesn't get messed up when I post this. My
question is which header do I use based on the above case audio
cables and where do I plug what? Thanks again.