1) The Compaq SR1303WM uses the VIA KM400 motherboard chipset. You need the
latest VIA AGP chipset (GART) drivers he
http://www.viaarena.com/default.aspx...D=1&CatID=1070

2) If your BIOS allows AGP speed adjustment, instead of 8x or Auto, set it
to 4x. Saw similar problems with my 9800 Pro back in the day (Battlefield2,
Half Life 2 all crash after 5 minutes or so). This solved it. If your BIOS
doesn't allow AGP speed adjustment, you can force it through the SmartGART
tab in the ATi control panel.

3) Be sure you have the latest version of DirectX installed. Microsoft
updates DX9.0c every two months or so, without rolling the version number.
Use the updater utility (released 10/24/2007) he
http://www.microsoft.com/downloads/d...displaylang=en

4) If nothing else solves the problem, then the weak 300W PSU may be to
blame. Even though Visiontek lists a 270W PSU as the minimum requirement, a
particularly low-quality PSU of higher wattage may not be able to support
the current draw.

--
"War is the continuation of politics by other means.
It can therefore be said that politics is war without
bloodshed while war is politics with bloodshed."


"St" wrote in message ...
Have posted on the visiontek site with no luck.. thought id try here....
This card runs fine as long as i don't try to run any DX9 3D games.. which
is what is got bought for.. Guildwars mostly
After anywhere from 10 to 30 minutes the machine will either lockup or
reboot.
Compaq SR1303WM
AMD Sempron 3000+ processor
1 GB SDRAM
80 GB 7200 RPM Serial ATA hard drive
New 300W power supply
Fresh install of system and drivers
Running the CAt7.6 that came with the card
Tried to install the 7.10 from visiontek and did worse

Any help here?
TIA
stubs