Thread
:
presario 4764 power supply start up ?
View Single Post
#
2
November 22nd 03, 02:18 PM
Sam Goldwasser
external usenet poster
Posts: n/a
(Kevin Falconer) writes:
I was just given a presario 4764 that had been working but then just quit..
no fan, no boot up, nothing. I installed a new power supply and still nothing.
I'm told the power supply will not come on without a signal from the MB. Anyone
know if perhaps a dead battery supply on the MB would prevent the main power
supply from coming on ? I have a hard time believing I got a bad power supply.
I dont want to dump the computer if perhaps a new battery on the MB will fire
up the power supply, thanks in advance for any comments.
Kevin Falconer Fort Myers, FL
A problem with the CMOS settings can prevent startup. Try resetting
the CMOS - there is probably a jumper for that. Check the CMOS battery.
--- sam | Sci.Electronics.Repair FAQ Home Page:
http://www.repairfaq.org/
Repair | Main Table of Contents:
http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ:
http://www.repairfaq.org/sam/lasersam.htm
| Mirror Site Info:
http://www.repairfaq.org/REPAIR/F_mirror.html
Important: The email address in this message header may no longer work. To
contact me, please use the Feedback Form at repairfaq.org. Thanks.
Sam Goldwasser