Jayant" wrote in message
:

The Printer Scanner has been working fine for quite some time. But after
getting the cartridge refilled, the PSC 1410 prints only the Test Report in
response to every command for printing a document. This has repeated at
least 20 times. Is there any way to stop this and start getting documents
printed as desired? There is no red light on any of the fault indicating
light points. So what could be wrong with the system?

When a new cartridge is installed the printer will print an alignment
page. This page is then loaded onto the scanner bed and the scan button
should be pressed to complete the alignment process. Check your manual
for information on the alignment process.

Until the alignment has been completed the printer will print an
alignment page after each print job.

Regards,
Bob Headrick, MS MVP Printing/Imaging