View Single Post
  #39  
Old November 28th 05, 05:06 PM posted to alt.sys.pc-clone.compaq
external usenet poster
 
Posts: n/a
Default Presario 2100 broken power connector


venkatfilms wrote:
Hi all..

I have a compaq presario 2100 model laptop. My ac jack is found to be
the problem. As discussed, i have thought of buying a docking station
for that. But, the latop i have doesnot have the docking connector
(bottom side of the notebook).

I just see a rectangular marking on the back side. WHat should i do?

1. buy a new backside case? or
2. is it possible to just mount that docking connector to my existing
backside case

Please gimme suggestions...

Also, how much does it cost just for docking connector or new backside
case...

Bye


I don't have a 2100, but I see by looking at Compaq's
"Maintenance and Service Guide" that the docking port connector
appears "on certain models" in the series. A new lower case half
(with a cutout and cover for the port) would not help, as the needed
connector (and probable support circuitry) would undoubtedly be absent
also. The odds of adding a connector would be slim. On most systems, it
typically mounts to the motherboard itself, so adding it -- even if
possible (or available!) -- would be far more complex than replacing
the DC power connector.

I do notice that the 2100 parts list shows a "port replicator
cover", and the bottom view drawings show a rectangular cutout shown
as "port replicator connect" on the bottom near the rear of the
notebook. Is yours just an outline in the case plastic as it appears,
or is it perhaps a removable cover? Take a close look... it would be
great if it's just there waiting for you to uncover! But if it's
not... then it's not, and won't be. Good luck!