On Wed, 9 Jan 2008 23:40:58 +0100, ******************
wrote:
I bought Silicom S2S DoubleSerial PCMCIA Card. And I have got a
problem. I installed DOS 6.22 and DOS drivers, but card was not working -
even, if IRQ and other parameters are manually specified.
Please look at this initialization communicat (it seems to be correct):
http://www.wlan.webd.pl/xxx/1.jpg
Then, when I would like to test it there is an error:
http://www.wlan.webd.pl/xxx/2.jpg
Does the manual tell you that you can test the serial port
without anything attached ? Did you attach something ?
Mostly, serial ports are tested with either a device or a loop
back plug attached.
I Would suggest to connect a loopback plug or, lacking one, some
serial device like a modem or a serial Mouse.
http://www.hardwarebook.info/ will tell you how to built a
loopback plug.
--
Kind regards,
Gerard Bok