On Fri, 19 Sep 2008 06:29:18 -0500, "Peter Olcott"
wrote:


A single-drive span is one that only has one member in it,
is typically how a drive is used on any non-raid
controller.

I must keep the drives separate, yet not in any RAID
configuration. What I must end up with is drive letters "C"
through "Z".


If the card supports 24 single drive spans, you would end up
with drive letters C through Z. If the manual does not make
both the factor of using single drive spans, AND supporting
24 of them clear, contact the manufacturer.