jimbo wrote:

I have physical hard drive "C" with Win98 and physical hard drive "D"
with WinXP in a dual boot setup. I want to injstall a new, larger
physical hard drive "D". I have tried to follow the procedure for
cloning a drive using Norton Ghost. I disconnected the cables from "C"
and connected the new hard drive. (I set the new drive's jumper to
"master" the same as the "C" drive.) Then Norton Ghost was booted from
floppies and I cloned drive 2 to drive 1. This all seemed to OK. Then I
disconnected the new drive and changed the jumper to "slave". Then I
reconnected the "C" drive. Then I disconnected the "D" drive and
connected the new drive in it's place. Now when I boot to WinXP it fails
just after the WinXP splash screen. A blue screen with an error message
appears and the system reboots.

Any insight will be appreciated.

jimbo

Hmm. I can't be sure because I can't see your registry but I suspect it's
because of how Windows XP serializes the drives and the new drive isn't
what it thinks should be the system drive (actually, it isn't 'anything'
when it first boots because it hasn't been identified and serialized yet,
but it may be by now, to whatever XP thought it should be).

On a single drive system it would normally figure out that the 'new' drive
is the 'new' C (if one removes the old one completely, else the OLD one
remains C and the new one gets a new letter, which causes all sorts of
problems) but with an existing drive as your boot drive I'm not sure how
it's resolving the new drive's letter, and that's what I suspect is going
wrong. Somehow it's getting confused as to which should be the 'C' drive
and which is the 'D' (or whatever).

What did XP call the two OLD drives? You say 'C' and 'D' but which was
which in Windows 98 and Windows XP. Did they both call each one by the same
letter?