View Single Post
  #3  
Old December 12th 03, 09:22 PM
Elector
external usenet poster
 
Posts: n/a
Default


"coop" wrote in message
om...
I have a MultiMedia #8950, S/N P196007583+,mother board PB911,

Floppy
Boot BPCS #143153-04, Master CD #175520-02, Recovery CD #172200-01,
Companion CD #172201-01. I couldn't seem to 'restore' my hard drive

to
its original state, so I did a 'Format c:' and erased my hard drive,
thinking I could restart with my floppy & Master CD & restore my
computer that way. No Luck! Everything seems to be ok when booting

up,
but then at the blue screen I get the message: "This Master CD is

for
use with a Packard Bell computer, if this is a Packard Bell computer
call tech support"... It doesn't recognize it's a PB???? It SAYS
Packard Bell on my monitor when booting up! I have been able to
re-install Win98se, but it lacks a lot of drivers! No sound, very
little color options, no modem, etc. How can I get the system to
recognize it IS a PB???? All of the disks seem to be fine when
accessing them in windows, but I just can't get the recovery to boot
all the way to where I can start the process! Please Help!! I read
about a 'tattoo' that I think may be my problem. However, when I
looked on the MasterCD in the drivers file, I could not find the
'tattoo' and the other file I needed to put on my boot disk in order
to re-install the original 'tattoo' on my hard drive. How can I find
the 'tattoo' & get it put back on my hard drive? (If this is indeed

my
problem).
Thank You!


Thanks to Simon's excellent instructions, Please follow the procedure
below.

Elector

################################################## ####################
##

TATTOO PROCEDU

Create a Windows 98 Boot Diskette
Locate on Master CD's the folder 'DRIVERS'
From this folder copy to the boot diskette the following files:

Tattoo.exe
Shellhs.dll

Remove old HDD and install your new HDD

Power up the system and boot from the diskette into DOS and at the A
prompt
enter the following command:

Tattoo /createhsfromdmi

This will transfer a copy of the tattoo from the motherboard bios to
the
hdd.


New Master CD Boot Disk can be downloaded here
ftp://ftp.pbnec.nl/pub/itemnr/6760030000/Disk1_1.exe


HTH

Simon