Computer will not start
On Jan 14, 10:37 pm, pcbldrNinetyEight pcbldrninetyeight.com wrote:
wrote : I did not build this computer ... but I am trying to fix it. The computer is a custom build. I have an Altec SLK1650 case. I am trying to track down a problem. If I can get the computer to start the computer works fine. When I press the button to start the computer it will make the appropriate sounds but within 1 second the computer dies. If I press the start button repeatedly it will act like it is going to start for progressively longer times until it finally it continues running. At this point the operating system is not running but the fans are running. I then push the reset button and then the computer start starts normally. I replaced the power supply (350W) with a 450W but that did not help. At this point the computer will not start at all. If I hold the reset button in and press the start button the computer will sound like it is running but will not boot. When I release the reset button the computer dies. Just wondering if it might have something to do with the start or reset buttons. Any suggestions will be greatly appreciated. Thanks in advance for the help ... Michael I don't know if that case uses stand offs for the MOBO (I'm too lazy to research now) but if one was left in the wrong place it could short out on the back of the board and cause the problem you describe. -- pcbldrNinetyEight I took a look at the stand offs. All of the screws through the MOBO have stand offs associated with them that are also screwed through the case. That possible issue does not seem to be a problem. One thing that I have read about on other threads is that there is a "POST beep" but I am not sure that I had one prior to this problem materializing. Michael |
All times are GMT +1. The time now is 06:34 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
HardwareBanter.com