HardwareBanter

HardwareBanter (http://www.hardwarebanter.com/index.php)
-   Cdr (http://www.hardwarebanter.com/forumdisplay.php?f=34)
-   -   Has anyone burnt an 80-min CD-R on a 7200i / CDD3610 under Linux? (http://www.hardwarebanter.com/showthread.php?t=26414)

Paul February 22nd 04 10:00 PM

Has anyone burnt an 80-min CD-R on a 7200i / CDD3610 under Linux?
 
After hearing the whispers that the HP CDWriter+ 7200i / Philips
CDD3610 can happily burn 80-min CDs, I've upgraded my 7200i's firmware
to r. 3.09, and have tried burning an 80-min audio CD. It seemed to
pass the OPC, and appeared to have no trouble with the first track,
but then cdrecord spat this out:

Track 01: Total bytes read/written: 31641456/31641456 (13453
sectors).
cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru
0x0
Sense flags: Blk 0 (not valid)
cmd finished after 124.045s timeout 120s
Trouble flushing the cache

Now the cdrecord man page says that

The following message is not an error:
Track 01: Total bytes read/written: 2048/2048 (1 sectors).
cdrecord: I/O error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 05 80 00 00 27 0A 00 00 00 00 B5 00 00 00
00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0xB5 Qual 0x00 (dummy data blocks added) Fru 0x0
Sense flags: Blk -2147483609 (valid)
cmd finished after 0.002s timeout 40s

It simply notifies, that a track that is smaller than the
minimum size has been expanded to 300 sectors.

This error looks just like the one I have, but the track size on mine
is 30MB! Not smaller than the minimum size, one would think!

The command I used was
`cdrecord -v speed=2 dev=0,0,0 -audio -pad *.wav`.

I've managed to record the same set of audio tracks on a 74-min
Imation CD-RW. So has anyone out there used an HP 7200i or a Philips
CDD3610 to burn 80-minute audio CDs successfully? I've read many
times that it can be done - but how?! Any help much appreciated!
Thanks,

Paul.

And now the details:

The CD-Writer's the slave on ide1 (/dev/hdd), and I'm running
Slackware 9.0.
The media: Sony CD-R CDQ80N4 (1x-40x compatible)

Here's the relevant stuff from `dmesg`:

hdd: HP CD-Writer+ 7200, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
hdd: attached ide-scsi driver.
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: HP Model: CD-Writer+ 7200 Rev: 3.09
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 6x/6x writer cd/rw xa/form2 cdda tray

Output of `cdrecord -v speed=2 dev=0,0,0 -audio -pad *.wav`

scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.25
Cdrecord 2.00.3 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jörg
Schilling
TOC Type: 0 = CD-DA
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 1
Vendor_info : 'HP '
Identifikation : 'CD-Writer+ 7200 '
Revision : '3.09'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC SWABAUDIO
Supported modes: TAO PACKET RAW/R16
Drive buf size : 786432 = 768 KB
FIFO size : 4194304 = 4096 KB
Track 01: audio 30 MB (02:59.37) no preemp
Track 02: audio 25 MB (02:29.42) no preemp
Track 03: audio 31 MB (03:09.40) no preemp
Track 04: audio 40 MB (04:03.48) no preemp
Track 05: audio 31 MB (03:09.45) no preemp
Track 06: audio 38 MB (03:50.77) no preemp
Track 07: audio 37 MB (03:43.18) no preemp
Track 08: audio 54 MB (05:22.10) no preemp
Track 09: audio 40 MB (03:59.48) no preemp
Track 10: audio 38 MB (03:51.44) no preemp
Track 11: audio 29 MB (02:56.26) no preemp
Track 12: audio 48 MB (04:51.18) no preemp
Track 13: audio 27 MB (02:46.17) no preemp
Track 14: audio 40 MB (04:00.80) no preemp
Track 15: audio 40 MB (04:03.50) no preemp
Track 16: audio 40 MB (03:58.69) no preemp
Track 17: audio 29 MB (02:53.26) no preemp
Total size: 632 MB (62:40.01) = 282001 sectors
Lout start: 632 MB (62:42/01) = 282001 sectors
Current Secsize: 2048
ATIP start of lead in: -11835 (97:24/15)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 24
Manufacturer: SONY Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 77848
Starting to write CD/DVD at speed 2 in real TAO mode for single
session.
Last chance to quit, starting real write in 0 seconds.
Operation starts.
Waiting for reader process to fill input buffer ... input buffer
ready.
Performing OPC...
Starting new track at sector: 0
Track 01: Total bytes read/written: 31641456/31641456 (13453 sectors).
cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 124.045s timeout 120s
Trouble flushing the cache
Writing time: 220.598s
Average write speed 17.5x.
Min drive buffer fill was 98%
Fixating...
cdrecord: Input/output error. close track/session: scsi sendcmd: no
error
CDB: 5B 00 02 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 1.998s timeout 480s
cmd finished after 1.998s timeout 480s


All times are GMT +1. The time now is 12:12 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
HardwareBanter.com